I did my regular oil/filter change two weeks ago. A few days later, I noticed that the OIL temperature needle is just sitting limp on the left pin even though the engine is fully warmed up. Also, the oil level indication doesn't work at start up.
Not surprisingly, when I put it up on jackstands this morning I found a loose wire dangling at the rear of the engine. No connector, just a wire with half an inch of insulation stripped off. The wire is bundled with three other wires. One goes to the sensor on the sump well, next to the drain plug. The other two wires go to a connector on the back of the engine. But I can't find where my loose wire belongs. (Being far-sighted, it's tough to focus on something two inches above my face.)
Can anyone tell me where this wire goes?
fs
Get Juno Platinum for as low as $4.97/month!
Unlimited Internet Access with 250MB of Email Storage.
Visit
http://www.juno.com/half to sign up today!
- Yahoo! Groups Sponsor --------------------~-->
What would our lives be like without music, dance, and theater?
Donate or volunteer in the arts today at Network for Good!
http://us.click.yahoo.com/2xaSZB/SOnJAA/Y3ZIAA/4jLplB/TM
--------------------------------------------------------------------~->
Recommended format for your email subject lines:
Model # [Model Letters] Year Subject
Examples:
505 88 V6 Mileage
405 Mi16 89 Ignition Coil source?
To unsubscribe from this list send a blank email message to PEUGEOT-L-UNSUBSCRIBE@EGROUPS.COM
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/peugeot-L/
<*> To unsubscribe from this group, send an email to:
peugeot-L-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Received on Sat May 21 08:58:20 2005
