As Kevin suggested, the manual suggests the first procedure so
replacing the bolts isn't necessary. DO replace the washers though.
On 7/7/05, Pug NZ <pug-yahoo2@azorah.co.nz> wrote:
> Does it use torque to yield bolts? If so, REPLACE.
>
> Normal bolt:
> Instructions = Torque to ** Nm, then to ** Nm. Retorque if necessary
> Bolt stays in elastic range (ie returns to same length on removal)
> Re-use okay
>
> Torque to yield bolt
> Instructions: Torque to ** Nm, tighten 90°.
> Bolt is permanently stretched during installation.
> DO NOT reuse bolt.
> DO NOT re-torque head.
>
> Kevin
>
> the505inme wrote:
>
> >When re/re ing the cyl head on a N9TE motor, do the head bolts have to
> >be replaced?
> >
> >
> >
> >
>
>
>
> Recommended format for your email subject lines:
> Model # [Model Letters] Year Subject
>
> Examples:
> 505 88 V6 Mileage
> 405 Mi16 89 Ignition Coil source?
> ************************************************
> To unsubscribe from this list send a blank email message to PEUGEOT-L-UNSUBSCRIBE@EGROUPS.COM
> ************************************************
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
Recommended format for your email subject lines:
Model # [Model Letters] Year Subject
Examples:
505 88 V6 Mileage
405 Mi16 89 Ignition Coil source?
To unsubscribe from this list send a blank email message to PEUGEOT-L-UNSUBSCRIBE@EGROUPS.COM
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/peugeot-L/
<*> To unsubscribe from this group, send an email to:
peugeot-L-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Received on Fri Jul 8 08:44:41 2005
